Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for White 1632
Summary of Contents for White 1632
- Page 7 ACCESSOR I ES Bobbin Felt Zigzag foot Button hole f (On machine) Machine Blind hem foot Buttor foot Zipper foot Button hole cutter Screw driver Needle —2—...
- Page 18 _______ _______ —...
- Page 19 —14-— I— ‘Li...
- Page 20 Important Hints. Raise the take-up lever to its highest position when starting and.stopping sewing. Hold both threads about 10 cms to th rear of machine for the first three stitches. Sufficient fabric should be placed under needle before lowering presser foot. Depress toot/Speed Control and start to sew.
- Page 21 is a —...
- Page 22 — —...
- Page 23 THREE STEP ZIGZAG The three step zig-zag stitch has a wide range of sewing applications, such as patching, darning, repairing tears, mending, sewing on elastic and lace, oversew ing edges etc. on a wide range of fabrics. The illustration shows patching, where the stitches are to the edge of the patch and a tear, where the stitches go firstly over the centre of the tear and then to either side but overlapping slighly on the first row.
- Page 24 OVERCASTING EDGES For thicker fabrics Both these stitches are designed to overlock the edge of a fabic. When the needle is at Its extreme right position, allow to just pass over or just pierce the edge of the fabric according to the effect you require. Using the overcasting foot will prevent puckering of thin fabrics.
- Page 26 1. Fit darning plate as described on page 12. 2. Use button presser foot and attach firmly. 3. Place button between presser foot and fabric and lower presser foot. 4. Manuaily turn hand wheel towards you ensuring that the needle enters into both holes of button without obstruction.
- Page 29 —i...
- Page 30 —...
- Page 31 CLEANING OF RACE AND SHUTTLE HOOK Raise the needle bar to its highest point by the hand wheel toward you. turning Open shuttle cover. 1) Take out the bobbin case. 2) Unlock the shuttle race holder. 3) Release the shuttle race cover. 4) Take out the shuttle hook Clean dust and gummed oil off each part with an oiled cloth.