Error Messages - Lenovo ThinkPad X230 Tablet Manual

Table 2. Numeric error codes (continued)
Symptom or error
2010
Warning: Your internal hard disk drive (HDD) may not
function correctly on this system. Ensure that your HDD
is supported on this system and that the latest HDD
firmware is installed.
201x
The solid-state drive you have installed has not passed
qualification for use in this computer. Using this drive may
cause compatibility issues and potential issues with data
integrity, including data loss. Press <Esc> to continue.
2100
Initialization error on HDD0 (Main hard disk drive)
2102
Initialization error on HDD1 (Ultrabay hard disk drive)
2110
Read error on HDD0 (Main hard disk drive)
2112
Read error on HDD1 (Ultrabay hard disk drive)

Error messages

Table 3. Error messages
Symptom or error
Device address conflict.
Allocation error for device.
Failing bits: nnnn.
Invalid system configuration data.
I/O device IRQ conflict.
38
Hardware Maintenance Manual
FRU or action, in sequence
Inform the following information to the customer: If in the
primary bay the customer is using a non-Lenovo hard
disk drive, which is not supported by this system, with
the risk in mind, the customer can still use it by pressing
ESC. If in the primary drive bay the customer is using a
supported Lenovo hard disk drive with an old firmware,
the customer needs to update its firmware to the latest.
The latest version is available at
http://www.lenovo.com/support
Inform the following information to the customer: If the
customer is using a non qualified solid-state drive which
is not supported by this system, with the risk in mind, the
customer can still use it by pressing ESC. Location of the
solid-state drive is designated as below:
2010: HDD0 (in hard disk drive slot-0)
2011: HDD1 (in hard disk drive slot-1)
2012: Ultrabay™ with hard disk drive adapter
1. Reseat the hard disk drive.
2. Main hard disk drive.
3. System board.
1. Reseat the hard disk drive.
2. Ultrabay hard disk drive.
3. System board.
1. Reseat the hard disk drive.
2. Main hard disk drive.
3. System board.
1. Reseat the hard disk drive.
2. Ultrabay hard disk drive.
3. System board.
FRU or action, in sequence
1. Load "Setup Defaults" in the ThinkPad Setup
program.
2. Backup battery.
3. System board.
1. Load "Setup Defaults" in the ThinkPad Setup
program.
2. Backup battery.
3. System board.
1. Memory module.
2. System board.
1. Memory module.
2. System board.
1. Load "Setup Defaults" in the ThinkPad Setup
program.
2. Backup battery.
3. System board.