Table of Contents
Advertisement
6
6
Electrical Information
A. Ignition System Wiring
• This gas stove is equipped with an electronic ignition
system which operates on a 6 volt system.
• The batteries are located within the ignition module
which is located behind the glass door assembly. A wiring
diagram is shown in Figure 7.1.
• The ignition module requires four AA batteries (not
included).
CAUTION
Battery polarity must be correct or module damage will
occur.
PILOT
Figure 6.1 Electronic Ignition Wiring Diagram
22
IGNITION MODULE
6VDC
BATTERY PORT
(4 AA BATTERIES)
ON/OFF
SWITCH
Heat & Glo • VRTIKL-AU • 2123-900 • 7/07
Shock hazard.
• Replace damaged wire with type 105º C rated
wire.
• Wire must have high temperature insulation.
CAUTION
Label all wires prior to disconnection when servicing controls.
Wiring errors can cause improper and dangerous operation.
Verify proper operation after servicing.
FLAME SPARKER/
SENSOR
PILOT GAS LINE
CONNECTED TO
BACK OF VALVE
WARNING
VALVE
REMOTE
CONTROL
ANT.
ON/OFF
WALL SWITCH
IGNITION
MODULE
(6V)
THERMOCOUPLE
BLOCK
(CONNECTED TO
BACK OF VALVE)
VALVE
Advertisement
Table of Contents
