Component Identification - NorthStar M459212B.6 Owner's Manual

1. Pneumatic Tires: Keep tire pressure at 30 PSI for
easy movement.
2. Unloader: Vents discharge air to atmosphere in
start/stop operation.
3. Lifting Eyes: May also be used as tie down locations.
4. Discharge Tube: Carries compressed air from pump
to safety/check valve, and then to the storage tank. It
becomes very hot during use and can cause severe
burns. Never touch.
5. Engine: NOT shipped with oil. Refer to engine
Owner's Manual for proper oil and capacity.
6. Engine Controls: Location of choke, engine speed
and fuel valve.
7. Engine On/Off Switch: Turn switch to "ON" when
starting engine. CAUTION: Unit is not equipped with
high temperature "auto shutoff". Do NOT allow to
overheat.
8. Manual Tube. Storage for safety manual.
9. Compressor Air Filter: Keep clean and particle free.
See "Pump Explosion and Pump Parts List" for
replacement part number.

Component Identification

10.
11.
12.
13.
14.
15.
16.
17.
18.
6
Air Compressor Pump: Shipped with oil.
Belt Guard: Covers belt, engine pulley and flywheel.
NEVER operate compressor without belt guard in
place.
Regulator: Adjusts outlet pressure, not to exceed
pressure rating of attachment tool.
Tank Pressure Gauge: Liquid filled gauge. Shows
pressure in receiver tank.
Regulated Pressure Gauge: Liquid filled gauge.
Shows regulated supply pressure.
ASME Safety/Check Valve: Automatically releases air
if tank exceeds preset pressure max. (150 PSI for
459212 & 200 PSI for 459222). A check valve is a
pressure release port. Pull valve pin to relieve pressure
from receiver tank.
Quick Connect: This is a ¼" quick connect.
Air Receiver / Storage Tank: 8 gallon twin tank.
Tank Drain Valve: Used to remove moisture from air
after compressor is shut off and air emptied from tank.
Drain moisture daily after each use.