Table of Contents
Advertisement
1.
Pneumatic Tires: Keep tire pressure at 30 PSI for
easy movement.
2.
Unloader: Vents discharge air to atmosphere in
start/stop operation.
3.
Lifting Eyes: May also be used as tie down
locations.
4.
Discharge Tube: Carries compressed air from pump
to safety/check valve, and then to the storage tank. It
becomes very hot during use and can cause severe
burns. Never touch.
5.
Engine: NOT shipped with oil. Refer to engine
Owner's Manual for proper oil and capacity.
6.
Engine Controls: Location of choke, engine speed
and fuel valve.
7.
Engine On/Off Switch: Turn switch to "ON" when
starting engine. CAUTION: Unit is not equipped with
high temperature "auto shutoff". Do NOT allow to
overheat.
8.
Manual Tube. Storage for owner's manual.
9.
Compressor Air Filter: Keep clean and particle free.
See "Pump Explosion and Pump Parts List" for
replacement part number.
Component Identification
6
10.
Air Compressor Pump: Shipped with oil.
11.
Belt Guard: Covers belt, engine pulley and flywheel.
NEVER operate compressor without belt guard in
place.
12.
Regulator: Adjusts outlet pressure, not to exceed
pressure rating of attachment tool.
13.
Magnetic Oil Drain: Removal allows for drainage of
oil from pump. Attracts metal particles that could
cause damage to pump.
14.
Tank Pressure Gauge: Liquid filled gauge. Shows
pressure in receiver tank.
15.
Regulated Pressure Gauge: Liquid filled gauge.
Shows regulated supply pressure.
16.
ASME Safety/Check Valve: Automatically releases
air if tank exceeds preset pressure max. of 150 PSI.
A check valve is a pressure release port. Pull valve
pin to relieve pressure from receiver tank.
17.
Quick Connect: This is a ¼" quick connect.
18.
Air Receiver / Storage Tank: 20 gallon ASME
certified tank.
19.
Tank Drain Valve: Used to remove moisture from air
after compressor is shut off and air emptied from
tank. Drain moisture daily after each use.
Advertisement
Table of Contents
