Check And Fill Gasoline Tank; Inspect Fuel System/Check For Leaks - NorthStar M459212B.6 Owner's Manual

Oil Cap
Sight
Glass
459222 Model Pump: The compressor pump capacity is
27 oz. Use SAE 30 non-detergent pump oil (part #4043)
prior to break-in. You may use synthetic lubricants after
50 hour break-in. See "Appendix A: Lubricants and
Compatibility" for a list of suitable and alternative
lubricants.
CAUTION: Synthetic lubrication hazard
If you will be using a synthetic lubricant, all downstream
piping material and system components must be
compatible.

Check and Fill Gasoline Tank

 Check the gasoline level in the engine's tank.
 Fill tank outdoors with fresh unleaded gasoline
from a portable container.
 Never pump fuel directly into engine at gas station.
Static charge can build and ignite fuel.
 Use a UL approved fuel container to transfer gas to
the engine.
 Always place container on ground to be filled. Keep
nozzle in contact with container while adding fuel.
WARNING: Fire/Explosion hazard
Gasoline is highly flammable and explosive. Heat,
sparks, and flames can ignite gasoline vapors, which
can become widespread during fueling. A flash fire
and/or explosion could result and cause serious injury
or death. Use extreme care when handling gasoline.
Carefully follow all the instructions in this section to
avoid the following conditions which could result in
gasoline ignition:
 gas vapor collection inside enclosures
 static electric sparks
 sparks from electric wiring, batteries, or running
engines
 sources of heat (such as a hot engine or exhaust)
 open flames, including pilot lights
 smoking
Breather Cap
Magnetic Drain
Figure 6
Plug
To Fill Gas Tank:
1. Before removing fuel cap, make sure compressor
has been off and allowed to cool for at least 2
minutes.
WARNING: Hot engine hazard
A running engine is hot enough to ignite fuel. Never add
fuel or remove gas cap if engine is running or still hot.
Let cool at least 2 minutes.
2. Remove fuel cap.
3. Add gas through the fill opening. Do not overfill.
Allow at least ½" of empty space below fill neck to
allow for gas expansion.
4. Replace fuel cap securely before starting engine.
5. Clean up fuel spills/splashes immediately.
If possible, move machine away from spilled

gas on the ground.
Wipe up spilled gas and wait 5 minutes for

excess gas to evaporate before starting
engine.
Gas-soaked rags are flammable and should

be disposed of properly.
If gas is spilled on your skin or clothes,

change clothes and wash skin immediately.
6. Store extra gas in a cool, dry place in a UL-
approved, tightly sealed container.

Inspect Fuel System/Check for Leaks

Inspect fuel system for leaks BEFORE starting
compressor. Look for:
Signs of leaks or deterioration

Chafed or spongy fuel hose

Loose connections

Loose or missing fuel hose clamps

Damaged gasoline tank

Selective gasoline shut-off valve

Do not start compressor until all needed repairs have
been completed.
14