Table of Contents
Advertisement
5. TCP-IP SETUP
ADVANCED SETUP PAGE
1. ALARM SETUP
2. MOTION SETUP
3. RECORD SETUP
4. EVENT
5. TCP-IP SETUP
6. PASSWORD SETUP
7. HDD FORMAT
8. HDD AUTO DETECT
9. FACTORY DEFAULT
> TCP-IP SETUP
CONNECTION SPEED: LAN / 512K / 64K
-IP ADDRESS
192.168.192.250 0080 (Factory Default)
-GATEWAY
192.168.192.001 (Factory Default)
-SUBNET MASK
255.255.255.000 (Factory Default)
-MAC ADDRESS
XXXXXXXXXXXXX. Machine number, user cannot change.
>Network Requirement:
LAN (Local Area Network)
1)
DVR side input local IP address such as 192.168.0.5, or use the factory default IP.
2)
After DVR network setting, install the remote viewer to computer. Computer network IP also need to
setup on local IP address such as 192.168.0.6. DVR and computer IP address cannot equal.
-Always 0080 port.
WAN (World Area Network)
1) User apply fixed IP from network, then input IP Gateway, and Subnet mask address to DVR TCP-UP setup.
2) Advice user apply network speed Upload 512K / Download 512K, to avoid image data too big influence the
remote quality. The network traffic jam always make data transfer slow, it is normal.
3)
After DVR TCP-IP setup, install the remote viewer to computer. See the remote viewer page.
-Port is depend on network company area, but normally is 0080 port.
TCP-IP SETUP PAGE
1. IP ADDRESS
000.000.000.000
2. GATEWAY
000.000.000.000
3. SUBNET MASK
000.000.000.000
4. MAC ADDRESS
000.000.000.000
Press direction buttons up/down/left/right to
TCP-IP items position.
Press values change button to change values.
35
Advertisement
Table of Contents
