Quadra-Fire 31M-ACC-MBK Owner's Manual page 21

R
7
Appliance Set Up
A. Pedestal Assembly and Ash Removal
System (ARS) Installation for Step Top
Uni-body
NOTE: The Ash Removal System, must be
installed first before installing the pedestal.
Included in Kit: Door assembly, door handle & magnet,
ash drawer, fastener package. A cover plate that is required
for a floor outside air installation on a pedestal model is also
included, If not needed, discard.
Tools Required: Phillips head screwdriver, 7/16 socket
wrench, /2 and 5/6 Allen wrench.
Begin installing the ARS System.
1. Remove 2 front bricks as shown in Figure 21.1.
2. Lay body of stove on its back on a protective pad or pallet.
. Remove the 2 nuts and 2 bolts holding the channel in
place and set the channel aside. Discard the 2 nuts.
Install the gasket over the 4 protruding screws.
The glossy side of the gasket needs to go against the firebox
bottom.
It is important the gasket is not put on upside
down as it could compromise its sealing capa-
bilities.
Figure 21.2.
4. Install ash door assembly by sliding the rod at an angle
into the slot on the left side. As the rod starts passing
through the slot, slide the handle over the rod and then
finish pushing the rod through the slot.
Slide the ash door over the 4 screws protruding from the
bottom of the stove. Secure with nuts provided. Figure
21.2.
5. Using a /2 Allen wrench tighten the set screw in the door
handle. The set screw needs to be snug. Figure 21.3.
6. Install magnet using a Phillips head screwdriver. This
magnet will hold the door handle in an open position
which in turn holds the ash door open so ashes can be
brushed into the ash drawer. Figure 21.2.
Do NOT operate before fully assembling components.
Burning your stove without a pedestal or leg kit
attached:
• Will void your warranty.
• May result in property damage or personal injury.
September 1, 2008
WARNING
Figure 21.1
Door Handle
Magnet
Slide rod at an
angle into slot
Figure 21.2
Set Screw
(align with flat
side of rod)
Door handle must be
in open position to
tighten set screw
Figure 21.3
7033-277F
3100 Wood Stove Series (ACC)
2
2
Remove for
installation and
then re-install
Gasket
Lay stove flat on
protective padding or
pallet
Ash Door
Assembly
Ash Door Rod shown
in installed position
Page 21