Terminal Module Wiring
Guidelines
22 Getting Started
User wiring to the Relay Matrix Switch modules is to the High (H) and Low
(L) connections on terminal module. Figure 1-10 gives guidelines to wire the
terminal modules. Maximum terminal wire size is No. 16 AWG. Wire ends
should be stripped 6mm (0.25 in.) and tinned. When wiring all channels,
use a smaller gauge wire (No. 20 - 22 AWG). The expansion connectors
allow you to create larger matrices. See "Creating Larger Matrices".
1
Remove clear cover.
A. Release screws.
B. Press tab forward
and release.
Tab
3
Make connections.
Screw-Type
VW1 Flammability
Insert wire into terminal.
Tighten screw.
5
Replace Wiring Exit Panel
Cut required
Keep wiring exit panel
holes in panels
hole as small as
for wire exit
possible
Figure 1-10. Wiring the Terminal Module
2
Remove and retain wiring exit panel.
4
Route wiring.
Use wire
size 16-26
AWG
5mm
0.2"
Rating
6
Replace Clear cover
A. Hook in the top cover tabs
onto the fixture
Remove 1 of the 3
wire exit panels.
Tighten wraps to
secure wires.
B. Press down and
tighten screws
Chapter 1