Table of Contents
Advertisement
E1469A Terminal Module
Connectors
Available Cables
Description
Module expansion connector
with quick disconnect
(twisted pair)
50
Coax
Dual banana instrument
SMB instrument
*TLA is a family of connector/cable assemblies with good transmission line design that are made by an Agilent supplier.
The 2-pin and 3-pin TLA connectors are designed to fit on one channel of the terminal module expansion connectors.
Chapter 1
Figure 1-9 shows the E1469A terminal module connectors and associated
row/column designators. Shielding jumpers JM1 - JM12 are shown. See
"Creating Larger Matrices" for information on using the expansion
connectors J1 - J5 and for shield wiring details.
NOTE
Jumpers JM1 - JM12 on the E1469A terminal module connect row/column
shields to earth ground through the VXIbus backplane. You may want to
remove one or more of these jumpers to reduce common mode noise.
Column Expansion
Column Input
Connectors
Connectors
*
*
In parallel with the screw terminals.
Figure 1-9. E1469A 4 x 16 Matrix Switch Terminal Block
To assist you in wiring Relay Matrix Switch terminal modules into your test
system, this table shows a list of cables that are available from Agilent.
Finished
Length
~30 cm
4 x 2 connector for
expansion connectors on
terminal modules
2.0 m
2-pin TLA*
2.0 m
3-pin TLA*
2.0 m
2-pin TLA*
Column
Connectors
Row Input
Row Expansion
Connector
*
*
End "A"
4 x 2 connector for
expansion connectors on
terminal modules
BNC (molded over)
Dual banana
SMB (molded over)
Row
Connector
Shield
Connector
Connector
*
TB5
End "B"
Part Number
E1468-80002
E1065-61620
E1066-61620
E1068-61620
Getting Started 21
Advertisement
Table of Contents
