Philips Lumea Quick Start Manual

Philips Lumea Quick Start Manual

Ipl hair removal system
Hide thumbs Also See for Lumea:

Advertisement

Lumea
IPL hair removal system
Quick Start
Guide

Advertisement

Table of Contents
loading

Summary of Contents for Philips Lumea

  • Page 1 Lumea IPL hair removal system Quick Start Guide...
  • Page 3: General Description

    General description Light exit window with integrated UV filter Body attachment (suitable for all body areas below the neck) Metallic frame inside the attachment Safety system (safety ring with contact switches) Flash button Intensity lights (1- 5) ▲ Intensity increase button ▼ Intensity decrease button Charging light and battery low indication On/off button ’Ready to flash’...
  • Page 4: Before Using

    This appliance is not suitable for everyone. This Quick Start Guide does not substitute the user manual. To ensure that Philips Lumea hair removal system is suitable for you and safe for you to use, read the user manual carefully before first use.
  • Page 5: Light Intensity Table

    Recommended light intensities table Consult the table on the following page to determine which light intensities are most suitable for your skin and body hair colour and check if this method is suitable for you. The method is more effective at higher intensities; however, you should reduce the light intensity if you experience any pain or discomfort.
  • Page 6: Using

    Preparing for use Charge the appliance. Shave the areas you intend to treat. Using Check the attachment and light exit window for any dirt, hair or fibres. If there is any contamination, clean it with the cloth supplied. Put on the attachment.
  • Page 7 Press the on/off button to switch on the appliance. Press the intensity increase/decrease button up or down to change the intensity (from 1 to 5). Place the appliance at a 90° angle on the skin so that the attachment and the safety ring are in contact with the skin.
  • Page 8 7 P ress the flash button to release a flash. Now you have 2 options to release the next flash: A K eep the flash button pressed. The appliance releases one flash after another as long as the safety ring is in full contact with the skin. Immediately after the appliance has flashed, slide the appliance to the next area. Make sure the safety ring is fully pressed onto the skin. This ‘Slide & Flash mode’ is especially convenient for treatment of larger areas like the legs. B L et go of the flash button after each flash.
  • Page 9: After Treatment

    (SPF 30+) in the two weeks after treatment. How to achieve optimal results To remove all hairs successfully and prevent the hair follicle from becoming active again, use Philips Lumea every two weeks for the first 4 to 5 treatments (more frequent treatments do not lead to faster or better results). In between treatments, the hair sheds naturally and hair regrowth is inhibited.
  • Page 10: Average Treatment Time

    Average treatment time: Area Approx. treatment time Underarms 1 minute per underarm Bikini line 1 minute per side Entire bikini area 4 minutes One lower leg 8 minutes One full leg 14 minutes Monitor your steps to smooth skin every day! Treatment no.
  • Page 11 Treatment no. Date Treated body area Next treatment date Used setting Note...
  • Page 12 ©2013 Koninklijke Philips Electronics N.V. All rights reserved. Document order number: 4222.100.1359.2...

Table of Contents