3D Eyewear - Registration; 3D Eyewear - Replacing Battery - Panasonic TH-P50ST60A Quick Manual

Clean using a soft, dry cloth.
●
– Wiping the 3D Eyewear with a cloth that is covered in dust or dirt may
scratch the eyewear. Shake off any dust from the cloth before use.
– The lens of the 3D Eyewear is easily broken. Be careful when cleaning
the lens.
Do not use benzene, thinner or wax on the 3D Eyewear, otherwise this
●
may cause peeling of the paint.
Do not dunk the 3D Eyewear in liquid such as water.
●

3D Eyewear - Registration

■
First registration
Perform the first registration when the 3D Eyewear is used for the first time.
1. Turn the TV on
2. Press Power button for about 1 second to turn the 3D Eyewear on
The lamp lights for about 2 seconds and then flashes.
●
The 3D Eyewear will be turned on and the registration will start.
●
Place the 3D Eyewear within 50 cm from the TV while registration in
●
progress.
3. After the registration is successfully completed, the 3D Eyewear will
reconnect with TV automatically when the 3D Eyewear is turned on near
the TV in 3D mode
■
Registration again
When connection with the registered TV fails, or when using with another TV,
re-register the 3D Eyewear.
1. Turn the TV on
2. Within 50 cm from the TV, press Power button until lamp lights, then
release it to start registration
3. After the registration is successfully completed, the 3D Eyewear will
reconnect with TV automatically when the 3D Eyewear is turned on near
the TV in 3D mode
= Note =
If the registration failed, the 3D Eyewear will be turned off. In this case,
●
turn the TV off and perform from step 1.

3D Eyewear - Replacing battery

When the battery is running low, the indicator lamp flashes 5 times on turning
- 38 -