Installation - Craftsman 919.195410 Owner's Manual

To Add Oil
before removing the oil fill cap or
oil drain plug.
1. Place unit on a level surface.
2. Remove oil fill plug (A) and slow-
ly add compressor oil until it is
even with the top of the oil fill
hole. NOTE: Do not allow oil to
be lower than 3/8" (6 threads)
from the top at any time. When
filling the crankcase, the oil flows
very slowly into the pump. If the
oil is added too quickly, it will
overflow and appear to be full.
Air Compressor Location
G
Locate the air compressor in a
clean, dry, and well ventilated
area.
G
The air compressor should be
located at least 12" away from
the wall or other obstructions
that will interfere with the flow of
air.
G
The air filter and flywheel must
be kept clear of obstructions
which could reduce air flow to
the air compressor.
G
The air compressor requires
fresh air flow for proper cooling.
DO NOT ALLOW THE COM-
PRESSOR TO GET WET.
GROUNDING INSTRUCTIONS
the event of a short circuit, ground-
ing reduces the risk of shock by
providing an escape wire for the
electric current. This air compres-
sor must be properly grounded.
D24910
Drain tank to
release air pressure

INSTALLATION

RISK OF ELECTRI-
CAL SHOCK. In
NOTE: Crankcase oil capacity is
approximately 16 fluid ounces.
3. Replace oil fill plug.
A
The portable air compressor is
equipped with a cord having a
grounding wire with an appropriate
grounding plug (see following illustra-
tions). The plug must be used with
an outlet that has been installed and
grounded in accordance with all local
codes and ordinances.
1. The cord set and plug with this
unit contains a grounding pin.
This plug MUST be used with a
grounded outlet.
IMPORTANT: The outlet being used
must be installed and grounded in
accordance with all local codes and
ordinances.
2. Make sure the outlet being used
has the same configuration as
the grounded plug. DO NOT
USE AN ADAPTER. See illustra-
tion.
Plug
Grounding Pin
12- ENG
Grounded
Outlets