Installing The Tower On Top Of The Subwoofer - Infinity PRELUDE MTS Owner's Manual

Hide thumbs Also See for PRELUDE MTS:

Service manual (36 pages)

User manual (24 pages)

Owner's manual (16 pages)

Table Of Contents

Table of Contents

Enlarged version

NSTALLATION

Please read through this owner's manual completely before

attempting to install or connect the speakers. We understand that

you may be anxious to play your new system, so we have made

every effort to simplify the installation and connections of the

Prelude MTS. However, there are still several times when you will

be asked to make a hookup or adjustment decision based upon

the details of your particular system and listening room.Your

patience will be rewarded with a loudspeaker system that is

optimized to your particular listening room in order to deliver

the best performance possible.

Before proceeding, you should decide how you would like to install

the tower portion of the Prelude MTS system.The tower may only

be attached to the powered subwoofer, mounted to our optional

floor stands, or mounted on the wall using the optional wall

brackets. In all cases, it is strongly recommended that two or three

people install the tower to minimize the possibility of damage or

injury.

Installing Feet

Refer to Figure B as you perform the following steps:

1. Open each accessory pack and locate the following items: feet

(with spike/round ends), four locking nuts, four nylon domes and

one wrench.

2. Lay each speaker on its side and locate the two threaded holes

on the bottom.

3. For carpets, screw the round end of a foot into each hole and

fully hand-tighten a nut onto each one. For hard-surface floors,

screw the spike end into each hole instead and leave the

rounded end exposed.

4. Carefully flip each speaker upright to sit on its feet.

5. If needed, adjust the feet so each speaker is level and then

tighten each nut with the enclosed wrench.To protect hard surfaces

(e.g., wood floors), slip a nylon dome onto each round end.

Note: Spiked feet must be fully threaded into holes provided in

base to ensure stability.

Locking Nut

⁄

min.

Foot

⁄

max.

spike end

CARPETED

FLOORS

– This cross section shows how to install the spikes

IGURE

onto the bottom of a Prelude MTS subwoofer or stand.

⁄

round end

Nylon Dome

(included for use

on wood floors)

HARD-SURFACE

FLOORS