Cleaning And Maintenance; For U.k. Only - DeLonghi EO1200 Series Instructions Manual

CLEANING AND MAINTENANCE

Frequent cleaning prevents the formation of smoke and bad odours
during cooking. Do not let fat accumulate inside the appliance.
Before any maintenance or cleaning operation, unplug the oven and
wait for it to cool down.
Clean the door, the inside walls and the enamel or painted surfaces of
the oven with a soap and water solution; dry thoroughly.
To clean the aluminium surfaces on the inside of the oven, never use
products that corrode aluminium (detergents in spray cans) and never
scrape the walls with sharp objects.
To clean the outside surface always use a damp sponge.
Avoid using abrasive products that may damage the paintwork.
Make sure water or liquid soap does not seep into the slits on the top
of the oven.
Never immerse the appliance in water; never wash it under a jet of
water.
All the accessories are washed like normal dishes, either by hand or in
the dishwasher.
If the oven has a crumb tray:
Remove the tray from the bottom (figure to the side); wash it by hand.
If the dirt is hard to remove, rinse the tray in hot soapy water and if
necessary rub it gently, without scratching it.

FOR U.K. ONLY

Wiring instructions
This appliance must be earthed
Important: The wires in this lead are coloured in accordance with the following codes:
Green and yellow: Earth
Blue: Neutral
Brown: Live
Connect the green/yellow wire to the terminal in the plug marked "E" (or by the
earth symbol) or coloured green or coloured green and yellow.
Connect the brown wire to the terminal in the plug marked "L" or coloured red.
Connect the blue wire to the terminal in the plug marked "N" or coloured black.
A 13 amp fuse should be fitted when the appliance is connected to a BS 1363 plug.
Seek professional advice if you are unsure of the correct procedure for the above.
About your factory fitted plug (supplied with certain models only)
The lead is already fitted with a plug incorporating a 13 amp fuse. If the plug does not fit your socket outlet,
see next paragraph. Should you need to replace the fuse in the plug supplied, a 13 amp approved BS 1362
fuse must be used. (refer to wiring instructions for use rating) If the plug supplied does not fit your socket out-
let, it should be removed from the mains lead and disposed of safely. The flexible cord insulation should be
stripped back as appropriate and a suitable alternative plug fitted. The replacement plug must be equipped
with a 13 amp fuse.
Important: If the electrical cord of this appliance is damaged, it must only be replaced by an authorised
Service Dealer. The safety of this appliance complies with the technical regulations and standards in force.
16
Green and Yellow or green
Fit13
amp
fuse
Brown
or red
Blue or
Use cable
black
gripper