Mitsubishi Electric MDT65IS User Manual page 46

OSD screen functions (continued)
„
AUTO BRIGHTNESS
This function controls the screen brightness depending on
the ambient light for easy viewing.
In addition, it changes the screen brightness depending on
the ambient light and what are displayed on the screen to
reduce power consumption as low as possible.
[AUTO BRIGHTNESS]
LOCAL: The auto brightness function is enabled.
REMOTE: The auto brightness function is enabled.
In addition, the monitor enters the
intercommunication mode where multiple
monitors are controlled collectively. (See page
52.)
OFF: This function is disabled.
[CONTROL]
PRIMARY: Select this setting to confi gure the monitor
as Master when controlling multiple
monitors collectively.
SECONDARY: Select this setting to use the monitor
alone or to confi gure the monitor as
Slave when controlling multiple monitors
collectively.
[LIGHT FROM BACK]
YES: Select this setting when there is a light source
such lighting equipment and a window behind the
monitor.
NO: Select this setting when there is no light source
such lighting equipment and a window behind the
monitor.
[BACK WALL]
Select the following settings according to the distance
between the rear of the monitor and the wall or window.
FAR: The distance is 5 meters or longer.
NEAR: The distance is 5 meters or shorter.
[FRONT SENSOR]
Select ON for normal use.
OFF: Select this setting when the sensor on the front
panel is shielded.
[REAR SENSOR]
Select ON for normal use.
OFF: Select this setting when the sensor on the rear
panel is shielded.
[SATURATION]
ON: The image saturation is adjusted depending on the
ambient light.
OFF: Image saturation isn't adjusted.
[VIDEO DETECT]
ON: The screen brightness varies depending on what
are displayed on the screen to reduce power
consumption of the monitor.
OFF: The screen brightness doesn't vary and the power
consumption isn't reduced.
„
PICTURE RESET
You can reset all the PICTURE settings to the factory
defaults.
English-42