Table of Contents
Advertisement
fit the new filter
21 Align the tabs on the top of the filter with the bulges underneath the reservoir.
22 Push the filter gently up, against the seal, and turn it anti-clockwise (about 1.5cm) to
lock it into the reservoir.
23 Slide the release button towards the handle, and hold it there.
a) lower the reservoir into the kettle.
b) slide the tabs on the front of the lid into the slots in the front of the reservoir
c) lower the rear of the lid into the reservoir
d) return the release button to its rest position
rinse the filter
24 Slide the fill button towards the kettle, to open the lid segments, and hold it there.
25 Fill the reservoir, through the lid, with about a litre of water.
, It's best to measure the water with a jug. It's difficult to measure a litre from a tap.
26 Return the fill button to its rest position.
27 Wait till the water runs through the filter, then pour it away.
28 Do this twice, fill again, and it's ready for use.
the filter life-timer
29 After you fit a new filter, you must set the
filter life-timer, so it can tell you when the
filter needs replacing.
30 The first time you see the timer, the display
will be blank, to conserve the battery.
31 Any other time you need to set it, it'll be
flashing, to tell you the filter needs replacing.
32 The display has 6 parts: bullseye, inner ring, and 4 outer segments.
set the life-timer
33 If you've fitted a standard two-month filter, press and hold the RESET button for
10-14 seconds, then let go (for a one-month filter, see "troubleshooting", page 7).
34 The inner ring and bullseye will flash alternately (shown here in grey),
and the top left outer segment will turn black (shown here in black).
, If the display shows anything else, see "troubleshooting", page 7.
35 That's it – the life-timer is set for a two-month filter.
36 Over the next two months (actually, it's 60 days), the display will change thus:
(grey = flashing, black = black, white = invisible)
when to change the filter
37 When the filter needs replacing, the display will go mad – in addition to
the bullseye and inner ring flashing, all 4 outer segments will flash – you
can't miss it.
5
Advertisement
Table of Contents
