Table of Contents
Advertisement
R
Two sizes: 9"d x 45"w and 12"d x 50"w, both 2" to10" Height Adjustment
Included in Kit: (
1) Trim Top, (1) Trim Front, (2) Trim Sides, Double-Sided Tape (already installed)
Tools Needed:
Phillips Head Screwdriver, Sheet Metal Shears, Measuring Tape, Gloves
1. The 10 screws on each set of scissors will already be loose
when shipped. Figure 16A.
2. Expand scissors to desired height. Tighten screws to hold in
place using Phillips Head screwdriver. Figure 16B.
. Measure front and side trims to required height to cover scis-
sors and mark pieces for cutting. Cut excess material from
top of trim's edge, not bottom. This edge will be sharp; wear
gloves to prevent injury to your hands. Figure 16B.
4. Using sheet metal shears, cut trim along the marked edge.
The cut edge fits under lip of top trim, so it allows for some
variance in your straight edge.
5. The double-sided tape that holds front and side trims to scis-
sors has a powerful bonding adhesive. Adjustments are
extremely difficult once trim has adhered to tape. Do a dry
run first without removing paper from tape.
6. Place cut edge of trim under top lip and into position on scis-
sors. Place side pieces on first and then front piece. The
front piece overlaps side pieces. NOTE: The trim in the Flush
Mount Kit is one piece.
7. Once you are satisfied with the positioning, remove trim and
set aside.
8. Remove the paper from double-sided tape that is to accept
trim side. Align side and then press hard against tape to
secure side piece. Repeat for other side. Install front trim
piece last.
NOTE: /8" (9.5mm) thick tile or like material can be cut to size and
fit under lip of top trim edge for a decorative touch. Figure 16C.
DOOR HANDLE ASSEMBLY
Washer
Nut 1/4-20
Door Latch Bracket
Figure 16D
DOOR lATCH ADJUSTMENT
I
t is important the door gasket has a proper seal. As the gasket compresses or
"seats" during use, it may become necessary to adjust or tighten the door latch.
1. Loosen securing screw (do not remove).
2. Turn adjustment bolts as need for adjustment (in or out) using 7/16" end
wrench.
. Tighten securing screw to hold adjusted position in place.
Page 16
4100-I ACT WOOD INSERT
ZERO ClEARANCE ADJUSTABlE TRiM SUPPORT
Hook Door Latch
Door Handle
Washer, 5/8 x 1/4
Fiber Handle
DOUBLE-SIDED TAPE
Figure 16A
EXpAND SCISSORS TO DESIRED HEIGHT
INSTALL FRONT TRIM LAST.
CORNERS OVERLAp SIDE
Figure 16B
Figure 16C
Figure 16E
250-7201E
EXPLODED VIEW OF SCISSORS
SCREWS ARE CIRCLED
DOUBLE-SIDED TAPE
CUT TOp EDGE OF TRIM,
NOT BOTTOM EDGE
TRIM pIECES
Securing
Screw
September 1, 2008
Decorative tile
may be installed
Adjustment Bolts
Advertisement
Table of Contents
