Configure Wep - NETGEAR MBR1515 User Manual

Settings
Security Options None
WEP
WPA-PSK (TKIP)
WPA2-PSK (AES)
WPA-PSK (TKIP) +
WPA2-PSK (AES)

Configure WEP

Note: If you use a wireless computer to configure wireless security
settings, you are disconnected when you click Apply. Reconfigure
your wireless computer to match the new settings, or access the
router from a wired computer to make further changes.

To configure WEP data encryption:
1. Log in to the router as described in
2. From the main menu, select Wireless Settings to display the Wireless Settings screen.
3. In the Security Options section, select the WEP
(Wired Equivalent Privacy) radio button:
4. Select the Authentication Type setting: Automatic,
Open System, or Shared Key. The default is Open
System.
Note: The authentication is separate from the
data encryption. You can select authentication
that requires a shared key but still leaves data
transmissions unencrypted. Security is stronger
if you use both the shared key and WEP
encryption settings.
5. Select the Encryption Strength setting:
• 64-bit. Enter 10 hexadecimal digits (any
combination of 0–9, a–f, or A–F).
LTE Broadband 11n Wireless Router MBR1515
Description
Use this setting to establish wireless connectivity before
implementing wireless security. NETGEAR strongly recommends that
you implement wireless security.
Use encryption keys and data encryption for data security. You can
select 64-bit or 128-bit encryption. See
Allow only computers configured with WPA to connect to the router.
See Configure WPA, WPA2, or WPA + WPA2
Allow only computers configured with WPA2 to connect to the router.
See Configure WPA, WPA2, or WPA + WPA2
Allow computers configured with either WPA-PSK or WPA2-PSK
security to connect to the router. See
+ WPA2 on page 28.
Log In to Your Router
Wireless Network Configuration
27
Configure WEP on page 27.
on page 28.
on page 28.
Configure WPA, WPA2, or WPA
on page 11.