Allowing Your Powerline Network To Coexist With A Homeplug Network - NETGEAR HDX101 User Manual

7. After WinPcap is installed, the InstallShield Wizard will indicate the HDX101 Configuration
Utility has been installed.
Figure 2-11
To launch the program, make sure the "Run NETGEAR HDX101 Configuration Utility"
button is checked. Click the Finish button to close the InstallShield Wizard.
Allowing Your Powerline Network to Coexist with a
HomePlug Network
This section only applies if your AC power lines host an existing HomePlug network, comprising
of devices such as NETGEAR XE102, WGX102, or XE104 adapters.
1. Make sure that all Powerline devices are plugged into AC power outlets.
2. If you have not already done so, start the HDX101 Configuration Utility and ensure that the
Main tab is selected.
Installing the Powerline HD Ethernet Adapter
HDX101 Powerline HD Ethernet Adapter User Guide
v1.1, May 2006
2-9