Remote Unit Advanced Buttons; Troubleshooting - Rotel RT-11 Owner's Manual

English

Remote Unit Advanced Buttons

Setup menu
To enter the setup menu, press the SETUP
and you will see the following display:
> 1 VERSION
2 EXIT
1. VERSION, shows the software version loaded in the unit.
2. EXIT, exits the setup menu.
DIM Button
F
Press this button to reduce the brightness of the front panel display.
QUEUE Button
B
This button is not used with the RT-11
BACK Button
D
This button is not used with the RT-11
REPLY Button
E
This button is not used with the RT-11
Transport Buttons
J
This button is not used with the RT-11
REPT Button
L
This button is not used with the RT-11
RANDOM Button
M
This button is not used with the RT-11
Note: The input buttons i-Radio, Network, and AUX not labeled in the
illustration figure 1, do not operate with the RT-11
C button on the remote control

Troubleshooting

Most difficulties in audio systems are the result of incorrect connections,
or improper control settings. If you encounter problems, isolate the area
of the difficulty, check the control settings, determine the cause of the
fault and make the necessary changes. If you are unable to get sound,
refer to the suggestions for the following conditions:
Power Indicator Is Not Lit
The power Indicator should be lit whenever the unit is plugged into the
wall power outlet and is pushed in. If it does not light, test the power
outlet with another electrical device, such as a lamp. Be sure the power
outlet being used is not controlled by a switch that has been turned off.
No Sound
1. Check the cables between the output and the pre-amplifier inputs, be
sure they are connected properly. Refer to Fig. 2.
11