Hunter Internet Thermostat Installation Manual page 3

2. Labeling Your Wires
A
Tip: To prevent your wires from falling back into the wall, wrap them around a pencil.
B
C
Remove the existing wall plate and/or thermostat
Alternatively, you may want to take a picture of the wires on your old thermostat for reference.
If you have any wire codes that do not match the Hunter labels, you may have a system that
does not conform to industry standard. Call our Technical Support at 1-888-830-1326.
Expose your existing thermostat wires.
Locate the wire terminals. If the wire terminals
are not visible, they may be connected to the
back of the wall plate.
DO NOT DISCONNECT THE WIRES
BEFORE LABELING THEM
Label your wires.
As you remove each wire one at a time, find
the Hunter label with the corresponding
letter code and attach it to the wire.
.