JVC KD-X50BT Instructions Manual page 21

Menu item
L/O MODE
(Line output
mode)
SUB. W *5
(Subwoofer)
SUB.W LPF *6
(Subwoofer low-
pass filter)
SUB.W LEVEL *6
(Subwoofer level)
HPF *6
(High-pass filter)
BEEP
(Keytouch tone)
AMP GAIN *7
(Amplifier gain)
SSM
MONO
(Monaural mode)
IF BAND
(Intermediate
frequency band)
RADIO TIMER
*5 Displayed only when <L/O MODE> is set to <SUB.W>.
*6 Displayed only when <SUB.W> is set to <ON>.
*7 The volume level automatically changes to "VOLUME 30" if you change to <LOW POWER>
with the volume level set to higher than "VOLUME 30".
Selectable setting (Initial: [XX])
Select if the REAR/SW terminals are used for connecting the speakers or
subwoofer (through an external amplifier).
SUB.W: Subwoofer
[REAR]: Speakers
OFF: Cancels.
[ON]: Turns on the subwoofer output.
LOW 55Hz/MID 85Hz/[HIGH 120Hz]: Audio signals with frequencies
lower than 55 Hz/85 Hz/120 Hz are sent to the subwoofer.
00 — 08 [08]: Adjusts the subwoofer output level.
LOW 100Hz/MID 120Hz/HIGH 150Hz: Activates the High Pass Filter.
Audio signal with frequencies lower than 100 Hz/120 Hz/150 Hz are cut off
from the front/rear speakers.
[OFF]: Deactivates. (All signals are sent to the front/rear speakers.)
[ON]/OFF: Activates or deactivates the keypress tone.
LOW POWER: VOLUME 00 — VOLUME 30 (Select if the maximum power of
each speaker is less than 50 W to prevent damaging the speakers.)
[HIGH POWER]: VOLUME 00 — VOLUME 50
For settings, page 6. (Displayed only when the source is "FM".)
Displayed only when the source is "FM".
[OFF]: Enables stereo FM reception.
ON: Improves the FM reception but stereo effect will be lost.
[AUTO]: Increases the tuner selectivity to reduce interference noises
between adjacent stations. (Stereo effect may be lost.)
WIDE: Subject to interference noises from adjacent stations, but sound
quality will not be degraded and the stereo effect will remain.
For settings, page 7.
Menu operations
ENGLISH | 21