Asko Dishwasher Use & Care Manual page 31

Installation
Slide the dishwasher into place
• Pull the drainage hose and connection pipe
when the machine is pushed into place.
• Check that the hose has no kinks or sharp
bends, and check that there is nothing that can
damage the hoses.
Installing the plinth (kick plate)
The dishwasher has two kick-plates (some
models). The taller one should be used if the
machine is to be 850 - 870 mm high and the
depth of the plinth can be varied between 45
- 105 mm. The lower one is to be used if the
machine will be 820 - 845 mm with a plinth
depth of between 50 - 105 mm. Attach the
enclosed felt insulation to the kick-plate (some
models).
Set the correct plinth depth as follows:
1. Bring the grey hooks towards each other
and pull out the brackets as far as required.
Press in the catches so that they lock the
brackets in place.
2. Suspend the kick-plate from the brackets
by pushing into the slots.
Screw the dishwasher into place
The enclosed plastic plugs are used for covering
the screw holes if the dishwasher is to be
screwed at the sides. After fixing check that the
front feet are in contact with the floor.
Fitting strip seal
(on floor plinth covering plate)
Proceed as follows:
1. Remove the plastic plinth by gripping with
both hands under the plastic plinth (A), and
lift outwards and upwards.
2. Undo the two screws on the covering plate
(B).
3. Glue the accompanying rubber strip (C) to
the underside of the covering plate (against
the floor).
4. Screw the covering plate back into place.
Adjust the covering plate so that the rubber
strip is just in contact with the floor.
x x
5. Replace the plastic plinth
Not all models
B
A
x
C
31