Healthrider H110i HRTL34306.0 User Manual page 10

10. Attach the ground wire on the Wire Harness (39)
to the indicated hole in the Base (52) with a
Ground Screw (84).
11. See the lower drawing. Position the Uprights
(53, 54) so that the treadmill Frame (51) is cen-
tered between the Uprights.
Firmly tighten the two Colored Patch Frame
Bolts (1) and the four Upright Bolts (2). Be care-
ful not to overtighten the Colored Patch
Frame Bolts.
12. Attach the Latch Housing (48) to the Left
Upright (53) with two Latch Screws (10); start
both Latch Screws before tightening them.
Make sure that the large hole in the Latch
Housing is on the indicated side.
Remove the knob from the pin. Make sure that
the collar and the spring are on the pin. (Note: If
there are two collars, place one on each side of
the spring.) Insert the pin into the Latch Housing
(48). Then, tighten the knob onto the pin.
Plug in the power cord (see OPERATION AND
ADJUSTMENT on page 11). Next, change the
incline of the treadmill to the lowest level as
described on page 13. If this is not done, the
latch may not hold the treadmill in the stor-
age position.
13. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key
in a secure place. The hex key is used to adjust the walking belt (see page 19). To protect the floor or carpet,
place a mat under the treadmill.
10
52
Ground Wire
Hole
11
54
11
48
Knob
10
Large Hole
10
39 84
1
2
51
Top View
51
53
Spring
Collar
Pin
53