Frigidaire GCEH1642DS1 Installation Instructions Manual page 8

7.
GAS CONNECTION (Gaslaundry centers only)
a. Remove the shipping cap from gas pipe at the rear of the
dryen
NOTE: DO NOT connect the laundry center to LR gas
service without converting the gas valve. An LR
conversion kit must be installed by a qualified gas
technician.
b. Connect a 1/2 inch (1.27 cm) I.D. semi-rigid or approved
pipe from the gas supply line to the 3/8 inch (0.96 cm)
pipe located on the back of the dryer. Use a 1/2 inch
(1.27 cm) to 3/8 inch (0.96 cm) reducer for the
connection. Apply an approved thread sealer that is
resistant to the corrosive action of liquefied gases on all
pipe connections.
c. Open the shutoff valve in the gas supply line.
d. Testall connections by brushing on a soapy water
solution. NEVER TEST FOR GAS LEAKS WITH AN
OPEN FLAME.
8. Form a " U " shape on the end of the drain hose with the
hose pointed toward the drain. Placethe formed end in a
laundry tub or a standpipe and secure with a cable tie
provided in the enclosure package. An air gap must ne
around the drain hose. WATER WILL SIPHONFROM
THE WASHER IF THE ABO VE INSTRUCTIONS ARE
NOT FOLLO WED.
9. Remove the two (2) screws securing the dryer front
access panel to the dryer cabinet. Lift the panel until the
tabs can be disengaged from the cabinet. Remove the
panel and set aside.
10. Connect the exhaust duct to outside duct work. Use
duct tape to seal all joints.
11. Plug the power cord into a grounded outlet.
NOTE: Check to ensure the power is off at a circuit
breaker/fuse box before plugging the power cord into an
outlet.
12. Turn on the power at a circuit breaker/fuse box.
_f__Before operating the dryer, make sure
the dryer area is clear and free from combustible
materials, gasoline, and other flammable vapors. A/so
see that nothing (such as boxes, clothing, etc.)
obstructs the flow of combustion and ventilation air.
13.
14.
Reinstall the dryer front access panel.
Run the washer and dryer though a cycle. Check for
proper operation.
NOTE: On gas dryers, before the burner will light, it is
necessaryfor the gas line to be bled of air. If the
burner does not light within 45 secondsthe first
time the dryer isturned on, the safety switch will
shut the burner off. If this happens, turn the timer
to "OFF"and wait 5 minutes before making
another attempt to light.
15. If your laundry center does not operate, please review
the "Avoid Service Checklist" located in your Owner's
Guide before calling for service.
16. Place these instructions in a location near the laundry
center for future reference.
NOTE: A wiring diagram is located behind the dryer
front access panel.
REPLACEMENT PARTS
If replacement parts are needed for your laundry center,
contact the source where you purchased your laundry center.
_estroy the carton, plastic bags, and metal
band after the laundry center is unpacked. Children might
use them for play. Cartons covered with rugs, bedspreads, or
plastic sheets can become airtight chambers causing
suffocation. Place all materials in a garbage container or
make materials inaccessible to children.
8
w , A.
: _L_'_vla_Label all wires prior to disconnection when
servicing controls. Wiring errors can cause improper and
dangerous operation. Verify proper operation after servicing.
_he instructions in this manual and all other
literature included with this laundry center are not meant to
cover every possible condition and situation that may occun
Good safe practice and caution MUSTbe applied when
installing, operating and maintaining any appliance.
Maximum benefits and enjoyment are achieved when all
the Safety and Operating instructions are understood and
practiced as a routine with your laundry tasks.