Before using the unit, please read this manual thoroughly and retain it for future
reference.
This symbol is intended to alert the user to the presence of
uninsulated “Dangerous voltage” within the product’s
enclosure that may be of sufficient magnitude to constitute a
risk of electric shock to persons.
This symbol is intended to alert the user to the presence of
important operating and maintenance (servicing) instructions
in the literature accompanying the appliance.
NOTE:
No user-serviceable parts inside. Refer servicing to qualified service personnel.
Copyright © 2008
< For EU Only >
by TOSHIBA TEC CORPORATION
TOSHIBA TEC Europe Retail Information Systems S.A.
All Rights Reserved
Rue de la Célidée 33 BE-1080 Brussels
570 Ohito, Izunokuni-shi, Shizuoka-ken, JAPAN
PRINTED IN INDONESIA
E
EO1-33084
7FM03295000
1
CE Compliance (for EU only)
This product complies with the requirements of EMC Directive including their
amendments.
NOTES:
1.This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
2.Changes or modification not expressly approved by manufacturer for compliance
could void the user’s authority to operate the equipment.
“This Class B digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulations. ”
“Cet appareil numérique de la classe B respecte toutes les exigences du
Règlement sur lematériel brouilleur du Canada.”
(for CANADA only)
3