Gigabyte GA-34SGCM-S2 User Manual page 43

Onboard LAN Boot ROM
This function decide whether to invoke the boot ROM of the onboard LAN chip.
•• Enabled Enable this function.
•• Disabled Disable this function. (Default value)
Onboard Serial Port 1
•• Auto BIOS will automatically setup the port 1 address.
•• 3F8/IRQ4 Enable onboard Serial port 1 and address is 3F8/IRQ4. (Default value)
•• 2F8/IRQ3 Enable onboard Serial port 1 and address is 2F8/IRQ3.
•• 3E8/IRQ4 Enable onboard Serial port 1 and address is 3E8/IRQ4.
•• 2E8/IRQ3 Enable onboard Serial port 1 and address is 2E8/IRQ3.
•• Disabled Disable onboard Serial port 1.
<3* Onboard Serial Port 2
•• Auto BIOS will automatically setup the port 2 address.
•• 3F8/IRQ4 Enable onboard Serial port 2 and address is 3F8/IRQ4.
•• 2F8/IRQ3 Enable onboard Serial port 2 and address is 2F8/IRQ3. (Default value)
•• 3E8/IRQ4 Enable onboard Serial port 2 and address is 3E8/IRQ4.
•• 2E8/IRQ3 Enable onboard Serial port 2 and address is 2E8/IRQ3.
•• Disabled Disable onboard Serial port 2.
Onboard Parallel Port
•• Disabled Disable onboard LPT port.
•• 378/IRQ7 Enable onboard LPT port and address is 378/IRQ7. (Default value)
•• 278/IRQ5 Enable onboard LPT port and address is 278/IRQ5.
•• 3BC/IRQ7 Enable onboard LPT port and address is 3BC/IRQ7.
Parallel Port Mode
•• SPP Using Parallel port as Standard Parallel Port. (Default value)
•• EPP Using Parallel port as Enhanced Parallel Port.
•• ECP Using Parallel port as Extended Capabilities Port.
•• ECP+EPP Using Parallel port as ECP & EPP mode,
cp ECP Mode Use DMA
This item will be available when "Parallel Port Mode" set to "ECP" or "ECP+EPP".
•• 3 Set ECP Mode Use DMA to 3. (Default value)
• И Set ECP Mode Use DMA to 1.
- 41 - BIOS Setup