Gigabyte GA-34SGCM-S2 User Manual page 26

IDE (IDE Connector)
An IDE device connects to the computer via an IDE connector. One IDE connector can connect to one
IDE cable, and the single IDE cable can then connect to two IDE devices (hard drive or optical drive).
If you wish to connect two IDE devices, please set the jumper on one IDE device as Master and the
other as Slave (for information on settings, please refer to the instructions located on the IDE device).
Before attaching the IDE cable, please take note of the foolproof groove in the IDE connector.
4 0
7) SATAIIO / 1 / 2 / 3 (SATA 3Gb/s Connector, Controlled by ICH7)
SATA 3Gb/s can provide up to 300 MB/s transfer rate. Please refer to the BIOS setting for the SATA
3Gb/s and install the proper driver in order to work properly.
ггт^еш fflim ашшошш
SATAII2
SATAIIO
SATAII3
SATAII1
Pin No.
Definition
1 GND
2 TXP
3 TXN
4
GND
5 RXN
6 RXP
7
GND
- 23 - Hardware Installation