Quick Guide
Before turning on the power
1
1
Connect the antenna (IEC 169-2) coaxial plug to RF IN.
Use CAI Benchmarked 75 ohm coaxial cable such as Triax TX100
2
Connect the HDMI™ cable
3
Plug in the receiver and switch socket on
Initial auto installation
When the Receiver is powered on for the first time, the First Time Installation screen appears.
Follow the on-screen instructions to search for all available channels.
Confirm the following before turning on the power
•
Is the antenna cable connected?
•
Is the receiver plugged in to a mains socket?
•
Is the HDMI™ cable connected between the receiver and your TV?
1
Ensure the antenna cable is connected before switching on.
2
Press the
key on the Receiver or Remote Control.
•
The First Time Installation screen is displayed.
3
Highlight Start Search, and press OK to start the channel search.
•
The Receiver will search for, sort and store all receivable channels.
NOTE
•
After the First Time Installation has been completed,
the default PIN is automatically set to '0000'.
To change the PIN setting, refer to Page 23.
2
9
3