GE MDS 4710A Technical Manual page 28

20
Table 9. Command Summary (Continued)
Command name
DTYPE [NODE/ROOT]
Details Page 26
DUMP Details Page 26
HREV Details Page 27
INIT Details Page 27
INIT [4710/9710] Details
Page 27
INIT [4720/9720] Details
Page 27
KEY Details Page 28
MODEL Details Page 28
MODEM [xxxx, NONE]
Details Page 28
OWM [XXX...] Details Page
28
OWN [XXX...] Details Page
28
PTT [0–255] Details Page
28
PWR [20–37] Details Page
28
RSSI Details Page 29
RTU [ON/OFF/0-80] Details
Page 29
RX [xxx.xxxx] Details Page
29
RXLEVEL [–20 to +6]
Details Page 30
RXTOT [NONE, 1-1440]
Details Page 30
SCD [0-255] Details Page
30
SER Details Page 30
SHOW [DC, PORT, PWR]
Details Page 30
SREV Details Page 31
STAT Details Page 31
TEMP Details Page 31
TOT [1-255, ON, OFF]
Details Page 31
MDS 4710/9710 Technical Manual
Function
(Diagnostics) Sets up a radio as a root or node
radio.
Display all programmable settings.
Display the Hardware Revision level.
Set radio parameters to factory defaults.
Configure radio for use outside of P-20 chassis.
Restores certain transceiver defaults changed by
the INIT x720 command.
Configure radio for service within a P-20
redundant/protected chassis.
Key the radio (transmitter ON). This is generally a
radio test command.
Display the model number of the radio.
Set the modem characteristics of the radio.
Set or display the owner's message.
Set or display the owner's name.
Set or display the Push-to-Talk delay in
milliseconds.
Set or display the transmit power setting.
Display the Received Signal Strength Indication.
Re-enables or disables the radio's internal RTU
simulator and sets the RTU address.
Set or display receiver frequency.
Set or display the receive audio input level.
Set or display the value of the receive time-out
timer.
Set or display the Soft-Carrier Dekey delay in
milliseconds.
Display the radio serial number.
Display the DC voltages, diagnostics port, and
transmit power level.
Display the Software Revision Level.
Display radio status and alarms.
Display the internal temperature of the radio in
degrees C.
Set or display the Time-out Timer delay in
seconds.
MDS 05-3305A01, Rev. E