Table of Contents
Advertisement
HOW TO USE THE ELLIPTICAL CROSSTRAINER
HOW TO PLUG IN THE POWER SUPPLY
Make sure that the power supply is plugged into the
elliptical crosstrainer (see step 6 on page 6). Next,
plug the power supply into an electrical outlet.
EXERCISING ON THE ELLIPTICAL CROSSTRAINER
To mount the elliptical crosstrainer, hold the handlebar
and step onto the pedal that is in the lowest position.
Next, step onto the other pedal. Push the pedals until
they begin to move with a continuous motion. Note:
The pedal disks can turn in either direction. It is
recommended that you move the pedal disks in
the direction shown below; however, to give vari-
ety to your exercise, you may choose to turn the
pedal disks in the opposite direction.
Pedal Disk
To dismount the elliptical crosstrainer, wait until the
pedals come to a complete stop. CAUTION: The
elliptical crosstrainer does not have a freewheel;
the pedals will continue to move until the flywheel
stops. When the pedals are stationary, step off the
highest pedal first. Then, step off the lowest pedal.
Pedal
7
USING THE UPPER BODY ARMS
The upper body arms are designed to give you a total
body workout. As you exercise, hold the upper body
arms and move your arms forward and back in order
to work your arms, back, and shoulders.
Upper
Body
Arms
Handlebar
If you want to exercise only your lower body, hold the
handlebar as you exercise.
INCLINE ADJUSTMENT
The incline frame can be raised or lowered to vary the
intensity of your exercise. To raise the incline frame,
lift the end of the incline frame until the crossbar is on
top of the incline bracket. Make sure that the incline
frame is resting securely upon the incline bracket.
To lower the incline frame, first lift the incline frame
slightly. Next, push the incline bracket toward the
upright and lower the incline frame onto the stabilizer.
Upright
Incline
Bracket
Crossbar
Incline
Frame
Stabilizer
Advertisement
Table of Contents
