Techness Run 200 User Manual page 17

ERROR
CODE
1. No safety key
E0 2. Safety key sensor broken
3. Safety key not work
1. Motor not work
2. Speed sensor not work
E1
3. Roller magnetic not work
4. Connect wire not work
E3:
1. Motor speed cannot be control
Only caused
2. Motor not work
when use
3. Speed sensor does not work well,
'MODE' key
no signal
No display on meter
Be sure the power is right.
If new treadmill, be sure the connect cable all pin is right.
If used treadmill, it maybe some PCB components broken or transformer broken. Let the
engineer check use multimeter.
Meter keys not work
All keys not work; no beep sounds，please check hand bar keys and meter keys will short
circuit.
A part key not work, no beep sounds, please lift the meter sticker to check this key,
sometimes is the key board not works.
PCB ERROR CODE AND SOLUTION (EWAY)
PROBLEM
1. Put safety key
2. Open the meter, replace sensor under the
safety key
3. Change the key.
1. Change or rework the motor
2. Change or rework the speed sensor
3. Change or rework the roller
4. Change or rework the wire
1. Change motor
2. Change motor
3. Change speed sensor
17
SOLUTION