HP ProLiant DL760 Quickspecs page 7

QuickSpecs
Standard Features
Intelligent Manageability HP Systems Insight Manager Intelligent Manageability Intelligent Manageability Intelligent Manageability
Availability Availability Availability Availability
Security Security Security Security
Server Power Cords Server Power Cords Server Power Cords Server Power Cords
UPS and PDU Power UPS and PDU Power UPS and PDU Power UPS and PDU Power
Cord Matrix Cord Matrix Cord Matrix Cord Matrix
Power Supply Power Supply Power Supply Power Supply
Remote Insight Lights-Out Edition ll (optional)
ROM-Based Setup Utility (RBSU)
Integrated Management Display (IMD)
Server Health logging
Automatic Server Recovery-2 (ASR-2)
System Interconnect Status Indicators
Remote-Flash Redundant ROM
Hot Spare Boot
NOTE: Upon the event of a failed processor or VRM in a multi-processing environment, the system will NOTE: NOTE: NOTE:
automatically reboot and use the remaining good processor(s).
Power Down Utility
Power Supply Viewer
Pre-Failure Warranty (covers processors, as well as SCSI hard drives and memory)
Hot Plug RAID Memory using Industry Standard ECC Memory
PCI-X/PCI Hot Plug with push button functionality
Redundant Hot Plug Fans
Dynamic sector repairing and drive parameter tracking (with Smart Array controllers)
Fault Tolerant Processor Power Modules
Redundant/adaptive load balancing NIC Support
Redundant Hot Plug Power Supplies
Power-on password
Diskette drive control
Diskette boot control
Network server mode
Security provision
Parallel and serial interface control
Administrator's password
Disk configuration lock
Hot plug access security
Two Highline IEC to IEC power cords (PDU adapters) ships standard
Please see the UPS and PDU cable matrix that lists cable descriptions, requirements, and specifications
for UPS and PDU units.
ftp://ftp.compaq.com/pub/products/servers/ProLiantstorage/power-protection/powercordmatrix.pdf.
Two Redundant Hot Plug 1150/500-Watt power supplies per system. Power supplies are load sharing
and provide 1150 Watts of Redundant power for 220-volt input or 500 Watts of Redundant power for
110-volt input.
NOTE: To ensure redundancy of server power, HP requires that 200-240 VAC power be used for all NOTE: NOTE: NOTE:
deployments. This will ensure that both power supplies can support up to their maximum configurations,
and remain in a redundant power supply state.
NOTE: A maximum of two power supplies are supported and ship standard with each server. NOTE: NOTE: NOTE:
DA - 11568 North America — Version 49 — March 27, 2006
HP ProLiant DL760 Generation 2 (G2) HP ProLiant DL760 Generation 2 (G2) HP ProLiant DL760 Generation 2 (G2) HP ProLiant DL760 Generation 2 (G2)
Page 7