Linkcom Link Gate A Premium Installation And Configuration Manual page 6

24 An analogue phones are not enable send "+" which is very used in GSM. In this case is possible to use combination
"00" to send it to mobile phone.
31 This feature identificated connection of Link Gate A Premium to external line at some type of PBX (ex : Siemens
Hicom). 29 This feature is used for searching of antenna best position. After feature activation you get tones
immediately. You end the feature by hang up.
32, 35
The GSM phones requested command to connection on inserted number. The Link Gate A Premium will send a
command immediately after acknowledge character dialling (#).
Notes:
Programming is only by tone dial DTMF. Don't forget set even external line at PBX.
 Changes are valid after hang up only (finishing of programming mode). It is very important especially in
acknowledge character changes- till hang up you must use previous acknowledgement.
 After numbers dialling you must wait for confirming request, insert acknowledge character and wait for confirming
tone. When you insert acknowledge character before wont be accepted.
 Switch to programming mode is possible even in busy tone.
 Some parameters are possible by software only
p.7 | 23