Husqvarna 966529102 Operator And Parts Manual page 8

1
DECK ADJUSTMENT
1. Locate the rear adjustment nut on the discharge
side of the deck. To assure the right tighteness,
mark the front side of the nut.
2. Using the mark as a guide, turn the nut clockwise
2½ turns with a ¾" wrench.
8
ASSEMBLY
3
MOUNTING BLOWER ASSEMBLY
1. Remove the discharge chute from the deck.
2. Lower deck to the lowest cutting position.
3. Remove the right hand (discharge side) belt cover
from the deck.
4. Position blower over the discharge tabs on the
deck and set blower onto the deck.
5. Be sure the blower is sitting flush against the
outside of the deck.
Contact Area
6. Install the front mount bracket to the deck with the
pin and hairpin cotter supplied with the kit.
Rear Mount Bracket
Hairpin Cotter
Outer Pulley
Cover
8063-072
Pin
8063-073