Operation - Hunter 90401 Owner's Manual

OPERATION

This appliance is for household use only.
1. Place the fan on a dry, safe, flat
surface where it cannot fall or
be pulled by the cord.
2. Plug the fan into a grounded
120-volt AC electrical outlet
(ordinary household current).
DO NOT use any other type of
outlet. Make sure that the rated
voltage of the fan is the same
as the power source before
plugging it into the power
source.
3. Turn the fan "ON" or "OFF" by
moving the power/speed lever.
The power should always be
OFF before unplugging the fan.
Power/Speed
Lever
4. To select the speed, move the
power/speed lever from OFF to
the desired speed setting: O (off),
I (low), II (medium), III (high).
5. To make the fan oscillate, push
the oscillation knob down. To stop
oscillating, pull the oscillation
knob up. The oscillation knob
is located on the top of the fan
housing, near the handle.
Handle
FIGURE 6
6
Oscillation Knob
Motor Housing
Base