Time Sync & Manualtime Setting - iHome iP10 Instruction Manual

SETTING THE TIME:
TIME SYNC & MANUAL
TIME SETTING
TIME SYNC
This unit is equipped with auto sync. By default, the unit will sync to the
time on your iPhone or newer iPod (iPod touch, iPod nano and iPod
Classic; older iPod models such as iPod mini do not support this feature)
whenever you dock it. You can also sync the unit to your docked iPhone
or iPod at any time by pressing and releasing the Time Sync Button
located in front of the dock. During time sync, "SYNC" will flash on the
display, indicating attempted time sync. When successful, the updated
time will appear on the display. If not, "FAIL" will appear in the display,
followed by a long beep. If this happens, try to sync again, or try using a
different iPhone or iPod. If sync still doesn't work, set the time manually
(see below).
SETTING THE TIME MANUALLY
1. Press and hold the Time Sync Button until "MAN" or "SYNC" flashes in the
display. If "SYNC" is displayed, press the + or – Buttons so "MAN" appears
in the display, indicating manual time setting mode.
2. Press and release the Time Sync Button. The time will flash in the display.
3. Press the + or – Buttons to set the correct time (hold for rapid adjustment.
Make sure you are setting the time to the correct AM or PM time. The PM
indicator appears at the upper left of the display; there is no AM indicator.
NOTE: The time can be set to standard 12 hour time (AM and PM) or to 24
hour time (sometimes called "military time"). To toggle between 12 and 24
modes, press and release the
any time during manual time setting mode.
4. Press and release the Time Sync Button to confirm the current time
setting (two beeps will sound) and exit time setting mode.
Alarm Button located on top of the unit at
6