Connecting To Ac Power - iHome iP10 Instruction Manual

C O N N E C T I N G T O A C P O W E R
This unit operates on AC power
using the included 100V-240V
universal AC adaptor for charging
and playing your iPhone or iPod .
Place unit on a stable surface. Plug
the power adaptor into the DC jack
on back of the unit and the other
end into a working wall socket. You
can now charge your iPhone or
iPod.
B A C K U P
The iP10 ships with a CR2450 battery installed for backup to provide
continuous alarm operation and clock settings in the event of a power failure.
Remove the pull tab from the battery compartment on the bottom of the unit
before use. If a power failure occurs or the AC cord is accidentally
disconnected, the display backlight will not remain lit, but current time and
alarm time settings will be temporarily maintained. Otherwise, you must reset
the time and alarm settings.
Note: The Battery Low icon is located at the right side of clock display.
When the backup battery is low and needs to be replaced, the Battery
Low icon will flash. To replace, follow steps below:
RESET
RESET
TEST
TEST
B A T T E R Y
7.5V 2.5A
3