USB
South Bridge:
-
U p to 14 USB 2.0/1.1 ports (8 ports on the back panel, 6 ports available
through the internal USB headers)
2 x Etron EJ168 chips:
-
U p to 4 USB 3.0/2.0 ports (2 ports on the back panel, 2 ports available through
the internal USB header)
* Be sure to connect your USB device(s) to the USB 2.0/1.1 ports before the USB 3.0
IEEE 1394
VIA VT6308 chip:
-
U p to 2 IEEE 1394a ports (1 port on the back panel, 1 port available through
the internal IEEE 1394a header)
Internal
1 x 24-pin ATX main power connector
Connectors
1 x 8-pin ATX 12V power connector
6 x SATA 6Gb/s connectors
1 x CPU fan header
2 x system fan headers
1 x power fan header
1 x front panel header
1 x front panel audio header
1 x S/PDIF Out header
1 x USB 3.0/2.0 header
3 x USB 2.0/1.1 headers
1 x IEEE 1394a header
1 x serial port header
1 x Clear CMOS jumper
1 x Trusted Platform Module (TPM) header
Back Panel
1 x PS/2 keyboard/mouse port
Connectors
1 x optical S/PDIF Out connector
1 x IEEE 1394 port
2 x USB 3.0/2.0 ports
8 x USB 2.0/1.1 ports
1 x RJ-45 port
6 x audio jacks (Center/Subwoofer Speaker Out, Rear Speaker Out,
Side Speaker Out, Line In, Line Out, Mic In)
I/O Controller
iTE I/O Controller Chip
Hardware
System voltage detection
Monitor
CPU/System temperature detection
CPU/System/Power fan speed detection
CPU overheating warning
CPU/System/Power fan fail warning
CPU/System fan speed control
* W hether the CPU/system fan speed control function is supported will depend on the
driver is installed. (Refer to the labels in section 1-7, "Back Panel Connectors.")
CPU/system cooler you install.
- 11 -
Hardware Installation