Vivitar DVR 850HD User Manual page 9

2. Use the battery clip found in the battery compartment to make sure that the battery is sitting firmly
and secure.
3. Before closing the battery door, be sure that the rubber seal on the battery door is clean and smooth.
4. Once powering on your camcorder the battery icon will appear on the top left of the LCD screen.
Charging the Lithium Battery
In order to charge your lithium battery,
1. Make sure the battery is inserted correctly.
2. Power off the camcorder.
3. Connect your camcorder to a running PC with the USB cable provided, or use the AC charger
provided in the package.
4. The red LED will light up indicating that your camcorder is in charging mode. The LED will switch off
when your camcorder is fully charged after approximately 4 hours. The camcorder should not be on
while charging.
Note:

A red battery icon will flash on the LCD when the battery power is insufficient. Shortly thereafter your
camcorder will power off.

Please remove your battery when you don't intend to use your camcorder for a long time.

Limited internal memory is provided in order to take photos and videos.

Use a SD Memory card to expand the memory in order to capture and record many more images. All
the images in the built-in memory will not be lost if no SD Memory Card has been inserted in the
DVR when battery power is low or when you change your battery.

Do not open the battery door to take out the battery or SD card while photos and videos are being
saved to the camcorder. Doing so may cause the photo and video to be lost or damaged.
8