Belt Changing And Agitator Cleaning - Kenmore 116.22803C Owner's Manual

BELT CHANGING AND AGITATOR CLEANING

TO REMOVE BELT
1. Turn Power-
®
Mate upside
down.
2. Unscrew the
two (2) Power-
®
Mate cover
screws.
3. Turn Power-
®
Mate right side
up. Press handle
release pedal and
lower the swivel.
Rear
Side
Lift rear latches
Latches
Latch
up.
4. To remove cover,
grasp the sides and
pull out.
5. Lift agitator
assembly out
and remove
worn belt.
End Cap
6. Check and clean end cap areas. See
AGITATOR ASSEMBLY for picture of
complete agitator assembly.
TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacuum
cleaner, the agitator must be cleaned every
time the belt is changed.
The agitator must also be cleaned accord-
ing to the following schedule:
Vacuum Cleaner Use Clean Agitator
HEAVY - every week
(used daily)
MODERATE - every month
(used 2-3 times/week)
LIGHT - every 2 months
(used 1 time/week)
IMPORTANT
Disconnect vacuum cleaner from
electrical outlet. Check and remove hair,
string and lint build-up frequently in the
®
Power-Mate agitator and end cap areas.
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove any string or debris
located on the agitator or end caps.
AGITATOR ASSEMBLY
Base
18
TUYAU
Interrupteur à trois positions
(OFF/ Floor / Carpet)
(Arrête/Plancher/Moquette)
Réglage
d'aspiration
Poignée
Pivot de
tuyau
TRAÎNEAU
Objet Pièce N o . Pièce N
aux
Etats-Unis Canadá
Sac à poussière 20-50557 20-50410
Filtre d'échappement 20-86889 20-40324
Filtre de sécurité 20-86883 20-40321
du moteur
ACCESSOIRES
o .
au
5