Table of Contents
Advertisement
2.
3.
4.
Find the adjustment tool that was supplied with your Batch Feeder. It
is a thin metal bar with notches cut at each end.
Use the adjustment tool to loosen the self-locking nut on the right
side on the rear of the Feeder as indicated in Figure 8.
NOTE! Do not touch similar looking nuts to the left.
Figure 8: Unlocking/locking the Feeder position
Use the software-assisted procedure to mount the Feeder to the scan-
ner as described in "Mounting the Feeder" on page 8. However when
you get to the last step, keep the
click on
)
Done
window open (do not
Mount feeder
Advertisement
Table of Contents
