Setting The Touch Panel - Sharp PN-ZT10E Operation Manual

Setting the touch panel

The TouchPanel Setting Program allows you to set or calibrate the touch panel.
For the procedure to install the programme, refer to page 12.
1. Click "TouchPanel Setting Program" on the taskbar.
2. Click appropriate buttons to change the setting as desired.
3. When the setting is complete, click "Close".
Tips
• The changed settings are stored in "C:\Program Files\tpdrv\tpdrv.ini".
Basic Setting
Port
Specify the COM port of the PC to which the touch panel is connected.
Normally, use "Auto Connect".
If "Auto Connect" does not work, select the COM port of the PC to which the touch panel is connected.
Calibration Mode
Normal : Select this option to use the normal view.
Special : Select this option for special cases such as using the enlarged view or clipped-and-enlarged
view.
Palm Touch
Select "Off" when you use your fi nger or the touch pen to touch the screen. Select "On" when you use
your palm to touch the screen.
PenID Setting/PenID Display
When more than one pair of touch panels and touch pens are used in proximity, specify ID numbers to
identify individual pairs. (See page 17.)
Calibration
Adjust the position so that the mouse cursor moves accurately to the touched point on the screen.
Follow the instruction displayed on the screen.
(To stop the calibration in progress, press any key on the keyboard.)
13
E