Setting Up The Pc - Sharp PN-ZT10E Operation Manual

Setting up the PC

To use the touch panel, you need to connect a PC to the touch panel and install the TouchPanel driver
and TouchPanel Setting Program onto the PC.
Installing the TouchPanel driver
Caution
• This procedure requires administrator privilege.
• To use a USB hub, select a model supporting bus power. USB hubs supporting self power cannot be used.
• Do not connect the USB cable until the OS starts up.
• Do not touch the touch panel while connecting the USB cable.
It will be detected as a failure of the infrared transmitter/receiver elements, leading to a malfunction. When this
occurs, disconnect the USB cable once and then reconnect it.
1. Turn on the monitor and PC to display the PC screen on the monitor.
2. Insert the supplied Utility Disk into the CD-ROM drive of the PC.
3. Connect the PC and touch panel with the USB cable (supplied).
To the USB
terminal of the PC
USB cable (supplied)
When the cable is connected, the "Welcome to the Found New Hardware Wizard" screen is displayed.
If the message "Can Windows connect to Windows Update to search for software?" appears, select "No,
not this time" and click "Next".
4. Select "Install the software automatically" and click "Next".
If the message "has not passed Windows Logo testing to verify its compatibility..." appears, click
"Continue Anyway".
5. Click "Finish".
The "Welcome to the Found New Hardware Wizard" screen is displayed again.
If the message "Can Windows connect to Windows Update to search for software?" appears, select "No,
not this time" and click "Next".
6. Select "Install the software automatically" and click "Next".
If the message "has not passed Windows Logo testing to verify its compatibility..." appears, click
"Continue Anyway".
7. Click "Finish".
This fi nishes the installation of the TouchPanel driver.
USB terminal
To the USB terminal
11
E