JVC GY-HM650U Instructions Manual page 119

Memo :
"On" cannot be selected if network connection
0
is not established.
"On" cannot be selected when FTP is running.
0
Live streaming switches to "Off" when the power
0
is turned off.
9 Resolution
For setting the resolution of the video image during
live distribution.
The camera recorder restarts when the setting is
changed.
The available options vary according to the settings
for [WResolution] and [WFrame & Bit Rate] under
[Record Format].
No. of Frames for
W Resolution WFrame & Bit
Rate
1920x1080, 60i, 30p
1440x1080
50i, 25p
1280x720 60p, 30p
50p, 25p
Memo :
The settings cannot be changed during live
0
streaming or recording.
9 Frame & Bit Rate
For setting the frame rate and encoding bit rate of
the video image during live distribution.
The available options vary according to the settings
for [Resolution] above, as well as [WFrame & Bit
Rate] under [Record Format],
No. of Frames for
WFrame & Bit Resolution
Rate
60i, 60p, 30p 1920x1080 R60i (H), 60i (L)
1280x720
720x480
50i, 50p, 25p 1920x1080 R50i (HQ), 50i (SP)
1280x720
720 x 576
Memo :
The settings cannot be changed during live
0
streaming.
Setting
values
(R: default
value)
R1920x1080,
1280x720,
720x480
R1920x1080,
1280x720,
720x576
R30p (HQ),
30p (SP)
R1280x720,
720x576
Setting values
(R: default value)
R30p (HQ), 30p
(SP)
R60i
R25p (HQ), 25p
(SP)
R50i
9 Type
For setting the transmission mode for the videos to
be distributed.
[Setting Values: MPEG2-TS/TCP, RMPEG2-TS/
UDP]
Memo :
This is normally set to "MPEG2-TS/UDP", but for
0
environments that are susceptible to packet
loss, setting to "MPEG2-TS/TCP" may
sometimes help to improve the video quality
during distribution.
"MPEG2-TS/TCP" can be used when this
0
camera recorder is used in combination with a
receiver unit that supports this transmission
mode.
9 Destination Address
For setting the IP address and host name for the
destination of live distribution.
9 Destination Port
For setting the network port number for the
destination of live distribution.
Connection Setup
For configuring the network connection settings.
Configure the settings by following the instructions
on the [Wizard] screen that is displayed according
to the type of adapter that is connected to the rear
[HOST] terminal.
You can Store, Load, or Delete the settings you
have specified on the [Wizard] screen.
9 Wizard
A [Wizard] screen appears according to the type of
adapter that is connected to the rear [HOST]
terminal.
Follow the instructions.
9 Load
Loads the settings on the [Wizard] screen.
(A P165 [Reading the Connection Settings
File] )
9 Store
Saves the settings on the [Wizard] screen.
(A P164 [Saving the Connection Settings File] )
9 Delete
Deletes the saved settings.
(A P165 [Deleting Connection Settings] )
119