Using Ac Power (Dc In Power); Power Status Display - JVC GY-HM650U Instructions Manual

Using AC Power (DC IN Power)

Use the supplied AC adapter to operate the camera
recorder with AC power.
POWER
2
ON
OFF
(CHG)
MODE
.
1 Connect the DC cable of the AC adapter to
the [DC] terminal of the camera recorder.
Check that the power switch of the camera
0
recorder is set to "OFF(CHG)".
Open the cover of the [DC] terminal and
0
connect as shown in the diagram.
2 Hold down the lock button (blue) at the
center of the [POWER ON/OFF(CHG)] switch
to set to "ON".
Power will be supplied to the camera recorder.
Caution :
Do not insert or remove the DC cable during
0
recording.
Do not use power supply of high voltage
0
fluctuation, containing noise such as ripple, or
with insufficient capacity.
Charging the Built-In Battery
The date/time and time code data are stored
0
using the built-in rechargeable battery.
When power is connected to the camera
0
recorder, the built-in battery always gets
charged. When the power is disconnected, the
battery gradually discharges.
The battery will be totally discharged if left
0
unused for 3 months and the date/time and time
code data will be reset. When this happens, set
the [POWER ON/OFF(CHG)] switch to "ON" to
display the [Initial Setting] screen, then set the
date/time.
(A P32 [Initial Settings] )
30

Power Status Display

Viewfinder Screen and LCD Monitor
The power status is displayed on the display and
menu screens.
Display
B 7.4V
B 100min
C 30%
4 RES
1
G
Memo :
If the supplied battery (or equivalent battery sold
0
separately) is not used, the battery mark which
indicates the battery level may not appear.
Display Screen
(A P126 [Display Screen in Camera Mode] )
(A P131 [Display Screen in Media Mode] )
282min
100min
50min
1920x1080
60 i HQ
4030 20 10
.
Menu Screen
(A P93 [Display and Description of the Menu
Screen] )
.
Description
Currently powered by a battery.
When the battery power runs out,
the battery mark appears hollow,
and "RES" (yellow) is displayed.
Memo :
You can set the display using
0
[LCD/VF] B [Display Settings]
B [Battery].
(A P108 [ Battery ] )
Currently powered by an AC
adapter.
00: 00: 00.00
Jan 24,2012
12 :34 :56
5 . 6f t
ND 1 /64
AE 6
+
0
dB
F1.6
0
P 13000K 1/ 100