NETGEAR GS724T Administration Manual page 6

To configure the MRP settings:
1. Enable or disable MMRP globally on the switch. MMRP provides an application to
register MAC address information. The default mode is Disable.
2. Enable or disable MSRP globally on the switch. MSRP provides an application to register
bandwidth requirement for a given AV stream. The default mode is Disable.
3. If you enable MSRP, configure the following MSRP settings:
a. Enable or disable MSRP talker pruning. The MSRP talker is the source of an AV
stream. Default mode is Disable.
b. Enable or disable the MRP Periodic State Machine for MMRP on the system. Default
mode is Disable. For this setting to take effect, MMRP must be enabled, but MSRP
does not need to be enabled.
c. Enable or disable the MRP Periodic State Machine for MSRP on the system. Default
mode is Disable.
d. In the MSRP Max Fan In Ports field, specify the maximum number of the ports
where MSRP registrations are allowed.
e. In the MSRP Max Frame Size field, specify the maximum frame size allowed for an
MSRP frame. The valid range for the frame size is 64–9216 octets.
4. Configure the 802.1Qav mapping for the Class A and/or Class B EAV streams. Class A
streams have a higher transmission priority than Class B traffic.
• In the EAV Priority field, specify the priority for each EAV stream class. The range is
0–7.
• In the EAV Remap Priority field, specify the remap priority for non-EAV traffic. The
range is 0–7.
GS716T and GS724T Gigabit Smart Switches
Ethernet Audio Video
7