Replacing The Front Audio And Usb Assembly - Lenovo ThinkCentre 0266 User Manual

4. Disconnect the internal speaker cable from the system board. See "Locating parts on the system
board" on page 10.
5. Press the internal speaker lock latch
chassis.
Figure 28. Removing the internal speaker
6. Position the new internal speaker into the metal clips
secured by the lock latch
7. Connect the new internal speaker cable to the system board. See "Locating parts on the system
board" on page 10.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 51.

Replacing the front audio and USB assembly

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the front audio and USB assembly.
To replace the front audio and USB assembly, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Open the computer cover. See "Opening the computer cover" on page 28.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 28.
44
ThinkCentre User Guide
1 , slide the internal speaker downwards to remove it from the
1 .
2 and push the internal speaker upwards until it is