Canon EOS 600 Instruction page 24

46
CUS-rOM FUNCTION CONTROL
This versatile, new control lets you program seven
functions to your ind,ividual preference.
1) Press the film winding mode selector and bat-
tery check button at the same time. The con-
trol number appears in the frame counter.
2) Turn the electronic
input dial in either
direction to set the
desired control.
3) Press the partial metering button to finish.
A bar mark appears to confirm setting. To
cancel a custom function press the partial
metering button again.
• To cancel a control and return to normal
function, r,epeat the above steps. The bar
d i sappea rs.
Set the main switch to "A" or (e»), At the green
mark, "0" controls
#
4, 5, and 7 can not be
used.
ClJSTOM FUNCTION CONTROL CHART
CONTROL USER-SELECTED NORMAL OPERATION
OPERATION
1 i
Film rewind cancellation
...
Cancels automatic film Film rewind starts
rewind operation
automatically at end of roll
2 Film leader out Leaves the film leader Film leader completely
outside the cartridge rewound into cartridge
3 Film speed set Cancels automatic film Film speed set by camera
speed setting of DX-coded according to DX-code
film
4 Autofocus start Initiates autofocus by
pre~sing
Autofocus starts when shutter
partial metering button. button pressed halfway
Partial metering is still
activated as long as this
button is depressed
5 Manual Aperture Set by electronic input dial Set by manual aperture set
exposure operation only button or display panel illu-
mination button
+
input dial
Shutter speed Set by manual aperture set Set by elect'ronic input dial
button or display panel illu- operation only
mination button
+
input dial
6 Camera shake warning tone Turns off camera-shake Tone sounds automatically
- cancellation warning tone with main switch at "0"
or (e»)
7 Manual focus operation with Allows manual focus adjust- Manual focus adjustment
USM lenses ment after autofocus without possible by setting focus
prior setting mode switch on USM lenses
47